Power Windows; Synchronizing - Mercedes-Benz 2010 CLS-Class Operator's Manual

219_AKB; 4; 54, en-US
d2ureepe,
and "Convenience closing feature"
( Y page 96).
i After switching off the ignition or
removing the SmartKey from the starter
switch, you can operate the door windows
until you open the driver's or front
passenger door. If no door was opened you
can operate the door windows for up to
5 minutes.
X
Switch on the ignition.
X
Opening/closing: Press or pull and hold
switch : to ? to the resistance point.
The corresponding door window moves
downward or upward until you release the
switch.
X
Express operation: Press or pull
switch : to ? past the resistance point
and release.
The corresponding door window opens or
closes completely.
X
Stopping during express operation:
Press or pull the respective switch again.
Closing when a door window is blocked
G
Warning!
Make sure that nobody can become trapped
and be seriously or even fatally injured when
closing a door window with greater force or
without automatic reversal function.
2009-05-11T16:21:02+02:00 - Seite 95
Version: 2.11.8.1

Power windows

If the upward movement of a door window is
blocked during the closing procedure, the
door window will stop and open slightly.
X
Immediately after the door window has
stopped because it was blocked, pull and
hold the respective switch upward until the
door window is fully closed.
The door window closes with greater force.
If the door window is blocked again and opens
slightly:
X
Immediately after the door window was
blocked, pull and hold the respective
switch upward until the door window is fully
closed.
The door window closes without automatic
reversal function.
G
Warning!
Pulling and holding the switch to close the
door window immediately after it had been
blocked two times will cause the door window
to close without any reversal function for as
long as you hold the switch.
Synchronizing door windows
The door windows must be synchronized after
the battery has been disconnected or if the
door windows cannot be fully closed (express
operation).
Each door window must be synchronized
separately.
X
Close all doors.
X
Switch on the ignition.
X
Pull and hold switch :, ;, = or ?
( Y page 95) until the respective door
window is closed.
The door window opens again slightly.
X
Pull and hold the respective switch once
more immediately until the door window is
closed completely.
X
Hold the respective switch for
approximately 1 second.
The door window is synchronized.
95
Z