Scanning Statistics - Viessmann vitocal 300-g Operating Instructions Manual

Scanning switching times
3. "Switching times HC1"
(Further options, see page 44).
4. > to run graphic displays.
Time is displayed in the
top l.h. corner; the selec-
ted operating mode to the
right of the graphic (for an
explanation of the IDs, see
pages 23, 30, 31 and 37).

Scanning statistics

Here, you can scan the following statistical values of internally connected compo-
nents:
■ "Hours run"
■ "Average runtime"
■ "No. of starts"
These internally connected components
are:
■ "Compressor"
■ "Compressor 2"
■ "Primary source"
■ "Primary source 2"
■ "Secondary pump"
■ "Secondary pump 2"
■ "Inst.water heat st.1"
■ "Inst.water heat st.2"
■ "Cylinder reheating"
■ "Ext. heat source"
■ "Pump heat. circuit 1"
■ "Pump heat. circuit 2"
■ "Pump heat. circuit 3"
■ "DHWcirServ"(e.g. for DHW circula-
tion pump)
■ "Central fault mess."
■ "Heating/DHW"
■ "Heating/DHW 2"
■ "Cyl. primary pump"
(cont.)
5. "BACK" to exit the menu.
■ "Swimming pool"
■ "Lag heat pump 1"
■ "Lag heat pump 2"
■ "Lag heat pump 3"
■ "Active Cooling"
■ "Natural Cooling"
Press the following keys:
1. "Information"
2. "Statistics"
3. "Hours run"
or
"Average runtime"
or
"No. of starts"
4. y/x for the required scan
Scanning options
45