Table of Contents
Advertisement
Updating
After you have loaded the DVD, you will
see a message to the effect that the disc
does not contain a recognizable audio for-
mat.
Confirming message: Press n.
COMAND checks whether the map
software on the DVD is compatible with
the vehicle's navigation system and
whether it is compatible with the cur-
rent system software.
Map software is compatible with the
navigation system and the current sys-
tem software
COMAND now checks whether the map
data on the DVD is already installed.
Map data is not yet installed
You will see a comparison of the version
statuses in the display and a prompt will
appear asking whether you want to contin-
ue with the update.
Select "Yes" or "No".
If you select "No", COMAND automati-
cally ejects the DVD and the map data
is not updated.
Take DVD out of the slot.
If you select "Yes", the map data is up-
dated.
Map data is already installed
You will see a message that the map data
is already installed and a prompt will ap-
pear asking you whether you want to con-
tinue with the update.
Select "Yes" or "No".
If you select "No", COMAND automati-
cally ejects the DVD and the map data
is not updated.
Take DVD out of slot.
If you select "Yes", the existing map
data is saved again.
Control systems
COMAND navigation (introduction)
Updating the map data
While the update is running, you will see a
message to this effect and a progress bar.
The progress bars fills up from left to right
during the update.
1 Progress bar
You can either cancel the update or allow
it to run to the end without canceling.
Canceling an update on the DVD
changer: Press corresponding maga-
zine tray button 2 ( page 184).
The DVD will be ejected in both cases.
Take DVD out of slot.
185
Advertisement
Table of Contents
