Table of Contents
Advertisement
Controls in detail
Loading
Pulling partition net tight
3 Lift tensioner
4 Tightening belt
5 Belt hook
6 Cargo tie-down ring
212
Lift tensioner 3 on tightening belt 4
must point in direction of the windshield
(indicated by the arrow).
Use lift tensioner 3 to set the length
of tightening belt 4 to cargo tie-down
ring 6.
Hook belt hook 5 into cargo tie-down
ring 6.
Pull tightening belt 4 by the loose end
until the partition net is slightly pulled
tight.
Fold the rear seat bench rearward until
it locks into place.
The partition net will be tightened by
the rear seat bench.
After driving a short distance, make
sure the partition net is still tight and, if
necessary, pull it tight again.
Installation partition net behind front
seats
Partition net installed behind front seats
Fold the rear seat bench (together with
the rear seat backrest) forward
( page 207).
Advertisement
Table of Contents
