Table of Contents
Advertisement
Warning!
Always wait until the procedure of shifting
from HIGH to LOW – and from LOW to HIGH
– has been entirely completed. During this
procedure do not:
switch off the engine
shift the automatic transmission into
another gear
If you do not wait until the shifting proce-
dure has been entirely completed then it
might not be correctly performed. The
transfer case might be in neutral, thus inter-
rupting the transfer of power between the
engine and the drive axle.
The vehicle is then freely movable, even if a
gear has been selected, and could uninten-
tionally be set into motion – particularly on
up – or downhill grades. This could lead to
an accident and cause injury to yourself and
others.
Please observe related messages appearing
in the multifunction display ( page 172).
Switching from HIGH to LOW
G
!
The shift procedure can only be performed
when:
the engine is running
the gear selector lever for the automatic
transmission is in neutral position N
the vehicle is not at standstill
the vehicle speed does not exceed 25 mph
(40 km/h)
Press upper half ("LOW") of the
transfer case switch.
Once the shift is complete, gear
position
L
appears in the transfer case
indicator 1 ( page 170).
i
If the shift procedure does not take place
press upper half ("LOW") of the transfer case
switch once more.
Move the gear selector lever to drive
position D.
Controls in detail
Transfer case
Switching from LOW to HIGH
!
The shift procedure can only be performed
when:
the engine is running
the gear selector lever for the automatic
transmission is in neutral position N
the vehicle is not at standstill
the vehicle speed does not exceed 40 mph
(70 km/h)
Press lower half ("HIGH") of the
transfer case switch.
Once the shift is complete, gear
position
H
appears in the transfer case
indicator 1 ( page 170).
i
If the shift procedure does not take place
press lower half ("HIGH") of the transfer case
switch once more.
Move the gear selector lever to drive
position D.
171
Advertisement
Table of Contents
