Table of Contents
Advertisement
Switching from LOW to HIGH
!
The shift procedure can only be per-
formed when:
The engine is running.
The gear selector lever for the auto-
matic transmission is in position N.
The vehicle is not at standstill.
The vehicle speed does not exceed
40 mph (70 km/h).
Press lower half ("HIGH") of the trans-
fer case switch.
Once the shift is complete, gear
position
H
is displayed in the transfer
case indicator.
i
If the shift procedure does not take
place press lower half ("HIGH") of the
transfer case switch again.
Put gear selector in D.
Messages in the multifunction display
If a shift was not completed and the multi-
function display shows one of the following
messages:
TC SHIFT CONDITIONS NOT FULFILLED
The shift did not take place. At least
one shift condition was not met.
Repeat the shift procedure.
TC IN NEUTRAL
The shift did not take place. The trans-
fer case is in neutral. The gear
position
N
is displayed in transfer case
indicator 1.
Repeat the shift procedure.
Warning!
If TC is in neutral, transmission position P
will not hold vehicle. The parking brake must
be applied to hold vehicle in place.
Controls in detail
TC SHIFT – CANCELLED
The shift did not take place.
Repeat the shift procedure.
TRANSFER CASE – VISIT WORKSHOP!
There may be a malfunction in the
system.
Repeat the shift procedure.
If the shift procedure still does not take
place, have the vehicle checked at an
authorized Mercedes-Benz Light Truck
Center as soon as possible.
i
If the SmartKey is in starter switch
position 0 or 1, an alarm will sound if
the transfer case is in position N and
G
the driver's door is opened.
Engage transfer case to gear position
HIGH or LOW.
For more information, see "Practical hints"
section ( page 319).
Transfer case
155
Advertisement
Table of Contents
