Table of Contents
Advertisement
!
Allow engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature
has been reached.
Shift into reverse gear R or parking po-
sition P only when the vehicle is
stopped.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces. This may cause
serious damage to the drivetrain which
is not covered by the Mercedes-Benz
Limited Warranty.
Steering wheel gearshift control
CLK 500
The steering wheel gearshift buttons are
located to the left and right of the steering
wheel.
1 Button, inside: downshift
2 Button, outside: upshift
i
You cannot shift with the steering
wheel gearshift buttons when the gear
selector lever is in position P, N or R.
The last selected program
mode (C or S) is switched on when the
engine is restarted.
Controls in detail
Automatic transmission
Downshifting
Warning!
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced
vehicle control. Your vehicle's ABS will not
prevent this type of loss of control.
Press the inside 1 of one of the but-
tons on the steering wheel.
The transmission will shift to the next
lower gear as permitted by the shift
program. This action simultaneously limits
the gear range of the transmission
( page 168).
G
173
Advertisement
Table of Contents
