Mercedes-Benz 2005 CLK 320 Operator's Manual page 157

Setting daytime running lamp mode
(USA only)
i
This function is not available in
countries where the daytime running
lamp mode is mandatory and therefore
in a constant mode.
Move the selection marker with
button æ or ç to the
submenu.
Press button j or k repeatedly
until the message Lamp circuit
headlamp appears in the multifunction
display.
The selection marker is on the current
setting.
Press æ or ç to select manual
operation ( manual
lamp mode ( constant
With daytime running lamp mode activated
Lighting
and the exterior lamp switch in
position M or U the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
Parking lamps
Tail lamps
License plate lamps
Side marker lamps
For more information on the daytime run-
ning lamp mode, see "Lighting"
( page 124).
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting
( page 147) while driving will not
) or daytime running
deactivate the daytime running lamp
) activated.
mode.
The following message appears in the
multifunction display:
Lighting – Cannot be completely
reset to factory settings while
driving
Controls in detail
Control system
submenu to factory settings
.
155