Table of Contents
Advertisement
Practical hints
Flat tire
Pump handle (three pieces)
1 Indent for activation of release bolt 2
Assemble the pump handle for the
jack. The pump handle is located in the
vehicle tool kit.
308
Jack
2 Release bolt
Close release bolt 2.
To do so, turn indent 1 to the right in
the pump lever until its stop.
i
Never turn release bolt 2 more than
one or two revolutions. Hydraulic fluid
can otherwise escape.
Place jack on firm ground.
Position jack under the axle housing,
so that it is always vertical (plumb-line)
as seen from the side, even if the vehi-
cle is parked on an incline.
Be certain the jack arm is positioned
correctly under the axle housing (axle
must fall into jack contour).
Jack up the vehicle by pumping (arrow)
until the wheel is clear of the ground.
Never start engine while vehicle is
raised.
Advertisement
Table of Contents
