Transfer Case - Mercedes-Benz 2004 G 500 Operator's Manual

Controls in detail

Transfer case

Switching from HIGH to LOW
!
The shift procedure can only be per-
formed when:
The engine is running.
The gear selector lever for the auto-
matic transmission is in position N.
The vehicle is not at standstill.
The vehicle speed does not exceed
25 mph (40 km/h).
Press upper half ("LOW") of the trans-
fer case switch.
Once the shift is complete, gear
position L is displayed in the transfer
case indicator.
i
If the shift procedure does not take
place press upper half ("LOW") of the
transfer case switch again.
Put gear selector in D.
146
Switching from LOW to HIGH
!
The shift procedure can only be per-
formed when:
The engine is running.
The gear selector lever for the auto-
matic transmission is in position N.
The vehicle is not at standstill.
The vehicle speed does not exceed
40 mph (70 km/h).
Press lower half ("HIGH") of the trans-
fer case switch.
Once the shift is complete, gear
position H is displayed in the transfer
case indicator.
i
If the shift procedure does not take
place press lower half ("HIGH") of the
transfer case switch again.
Put gear selector in D.
Messages in the multifunction display
If a shift was not completed and the multi-
function display shows one of the following
messages:
TC SHIFT CONDITIONS NOT FULFILLED
The shift did not take place. At least
one shift condition was not met.
Repeat the shift procedure.
TC IN NEUTRAL
The shift did not take place. The trans-
fer case is in neutral. The gear
position N is displayed in the transfer
case indicator 1.
Repeat the shift procedure.
Warning!
If TC is in neutral, transmission position P
will not hold vehicle. The parking brake must
be applied to hold vehicle in place.
G