Table of Contents
Advertisement
Safety and Security
Occupant safety
Child seat anchors – "LATCH" type
This vehicle is equipped with two "LATCH"
(Lower Anchors and Tethers for CHildren)
type anchors (at each of the outer rear
seats) for the installation of a "LATCH"
child seat with the matching mounting fit-
tings.
The anchors are located between the seat
cushion and the backrest.
Grip inner side of anchors 1 and fold
forward until they lock in place.
Install child seat according to the
manufacturer's instructions.
70
i
The child seat must be firmly attached
in the right and left side anchors 1.
With a child seat installed in the left rear
seat, the seat belt for the center seat occu-
pied by a passenger must operate freely.
Guide seat belt between its seat cushion
anchor and backrest anchor along outside
of right side child seat anchor.
To fold anchors back
Press down button 2 on each anchor
and return anchor to its catch.
i
Non-"LATCH" type child seats may also
be used and can be installed using the
vehicle's seat belt system. Install child
seat according to the manufacturer's
instructions.
Warning!
Children too big for child restraint systems
must ride in back seats using regular seat
belts. Position shoulder belt across chest
and shoulder, not face or neck. A booster
seat may be necessary to achieve proper
belt positioning for children from 41 lbs. un-
til they reach a height where a lap/shoulder
belt fits properly without a booster.
Before installing the child seat, make sure
anchors 1 are folded out and locked in
place.
Install child seat according to manufactur-
er's instructions.
G
Advertisement
Table of Contents
