Head Restraints - Mercedes-Benz 2003 CL 500 Operator's Manual

Head restraints

Information on head restraint adjustment
can be found in the "Getting started" sec-
tion ( page 36).
Warning!
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint to support the back of
the head approximately at ear level.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
i
Tilt the seat backrest to the rear for
easier removal and installation of the
head restraints.
Front seat head restraints
G
Removing front head restraints
Press switch 1 upwards and hold until
the head restraint is fully extended.
Pull out head restraint.
Installing front head restraints:
Press switch 1 upwards and hold for
about five seconds.
Push the head restraint down until it
engages.
Adjust head restraint to desired posi-
tion ( page 35).
Controls in detail
Rear seat head restraints
Warning!
For safety reasons, always drive with the
rear head restraints in the upright position
when the rear seats are occupied.
Keep the area around head restraints clear
of articles (e.g. clothing) to not obstruct the
folding operation of the head restraints.
i
You can adjust the angle manually by
pulling or pushing the head restraints
by hand.
Folding rear head restraints back
Make sure the ignition is switched on.
All the lamps in the instrument cluster
should light up.
Seats
G
97