Programmed Playback - Memorex MKS8730 User Manual

PROGRAMMED PLAYBACK

The CD player in this unit has a 30 track programmable memory that allows you to program up to 30 tracks
on any disc for playback in any desired order. You may program 30 different tracks or you may also program
certain tracks to play more than once.
To perform programmed playback, proceed as follows:
1
1
Press the POWER button ‚ to
turn the unit on. Rotate the
FUNCTION switch ƒ to the CDG
position.
4
1
2
Press the DISC SKIP button 1 or
DISC 1,2 or 3 button 2 to select
the desired disc.
7
2
1
To clear programmed playback, while in the Stop mode, press the PROGRAM button followed by the
STOP (I) button or open the CD door.
To check the programmed tracks, while in the Stop mode, press the PROGRAM button repeatedly to view
the programmed tracks.
OPERATION (CONTINUED)
2
2
2 1
Press the OPEN/CLOSE button 1 to
open the CD Carousel Door and insert
up to two CDs with the label side facing
upward and the shiny side facing
downward. Note the disc location
number(s) in the compartment as they
correspond to the Disc 1, 2 and 3
buttons. Press the Disc Skip button 2 to
rotate the tray and insert a third disc (if
desired). Close the CD Carousel Door by
pressing the OPEN/CLOSE button 1.
5
3
When "00" blinks again in the display,
press either the SKIP/SEARCH o 1
or n 2 button to select the track you
wish to program. When the desired
track number appears in the display,
press the PROGRAM button „ again.
Press the PLAY/PAUSE (
playback; playback will begin on the first track that you programmed.
The player will continue to play all of the tracks that you programmed
in the order in which you programmed them. When the last
programmed track has been played, the player will stop and the
display will show the total number of tracks on the last disc played. If
you press the PROGRAM button ƒ and then press the PLAY/PAUSE
p) button ‚ again, playback will start on the first track you
(
programmed and will continue until all the programmed tracks have
been played.
3
Press the PROGRAM button; "01"
will appear in the display for two
seconds, then "00" will blink in the
display.
6
2
When "00" blinks again in the
display, repeat steps 4 and 5 until
you have programmed the
desired track numbers into the
CD Program Memory.
p) button ‚ to begin programmed
15
2
1
2