NOTE: Follow the disassembly procedure as shown in the flow chart below.
LCD unit,
2-5.
PD-104 board
EVF block (1),
2-1.
RL-52 board
NOTE: Follow the disassembly procedure in the numerical order given.
2-1. EVF BLOCK (1), RL-52 BOARD
!¢ Cabinet (EVF) assembly
0 Screw (M2 × 4),
lock ace, P2
In case of removing
the RL-52 board
RL-52 board
Claws
SECTION 2
DISASSEMBLY
2-2.
Cabinet (ST) assembly,
2-4.
FLASH unit, MA-348 board
2-6.
LENS block
CD-207 board, VP-49 board,
2-7.
SE-78 board
2-8.
FC-67 board, DD-119 board
PK-45 board,
2-9.
FDD block assembly
!∞ EVF block
Remove the FP-68 flexible board
from the cabinet (ST) assembly
with care so that the board must
not be caught.
!£ Remove
the claws
Cabinet (ST)
assembly
(See page 2-3)
5 Shaft (POP)
1 Two screws (M2 × 4),
lock ace, P2
a
3 Cabinet (RL) assembly
EVF block (2)
2-3.
VF-131 board
4 Cabinet (microphone) assembly
a
2 Tapping screw (B2 × 5)
9 Pull up the LCD block assembly
2-1
MVC-FD91
LCD check
Service position
EVF check
Service position
FLASH UNIT
replacement
LENS unit check
Service position
MAIN (FC-67) board check
Service position
Overall check
Service position
8 Screw (M2 × 4)
6 Pull the knob
in the direction
of the arrow.
8 Screw (M2 × 4)
7 Open the flash lid.
!™ Screw (M1.7)
!¡ FP-68 flexible
board (21P)
8 Screw (M2 × 4),
lock ace, P2