Ford 2013 Explorer Owner's Manual page 346

Hide thumbs Also See for 2013 Explorer:

Table of Contents

Replacing fog lamp bulbs

1. Make sure the headlamp switch is off.

Reverse steps to reinstall bulb(s).

Replacing turn/backup lamp bulbs

The turn/backup lamp bulbs are located in the same area of the tail lamp

assembly, one below the other. Follow the same steps to replace these bulbs:

1. Make sure the headlamp switch is in the off

position, then open the liftgate to expose the lamp

assembly bolts.

2. Remove the two bolts covers using a standard flat

tip screwdriver.

3. Remove the two bolts from the lamp assembly.

4. Carefully remove the lamp assembly away from the

vehicle by pulling the assembly straight out to expose

the bulb socket.

2013 Explorer (exp)

Owners Guide gf, 2nd Printing

1. Make sure that the fog lamp switch

is in the off position.

2. Remove the bulb socket from the

fog lamp by turning it

counterclockwise.

3. Disconnect the electrical

5. Remove the bulb socket from the

lamp assembly by turning it

counterclockwise.