Ford 2013 Explorer Owner's Manual page 344

Hide thumbs Also See for 2013 Explorer:

Table of Contents

Replacing headlamp bulbs

WARNING: Handle a halogen headlamp bulb carefully and keep

out of children's reach. Grasp the bulb only by its plastic base

and do not touch the glass. The oil from your hand could cause the

bulb to break the next time the headlamps are operated.

Note: If the bulb is accidentally touched, it should be cleaned with

rubbing alcohol before being used.

1. Make sure that the headlamp control is in the off position.

2. Open the hood.

5. Disconnect the electrical connector.

Reverse steps to reinstall bulb(s).

Replacing HID headlamp bulbs (if equipped)

The headlamps on your vehicle use a "high intensity discharge" source.

These lamps operate at a high voltage. When the bulb is burned out, the

bulb and starter capsule assembly must be replaced by your authorized

2013 Explorer (exp)

Owners Guide gf, 2nd Printing

3. Remove the bulb cover.

4. Turn the bulb base counterclockwise and remove