Specifications; Replacement Parts - Schumacher SP6 Owner's Manual

PROBLEM
The charger will not
turn on when properly
connected.
Green LED is solid
and the display shows
ANALYZING BATTERY.
Green LED is flashing
and the display shows
CHARGE ABORTED-
BAD BATTERY.
The display shows
CONNECT CLAMPS.

16. SPECIFICATIONS

Input Voltage ..................................................................120V AC @ 60Hz, 1.5A
Output Voltage ........................................................................................12V DC
Output Current Rating .........................................................................6A @ 12V

17. REPLACEMENT PARTS

Battery clamps (quick-connect) ....................................................... 3899003431
12V accessory plug (quick-connect) ............................................... 3899003432
Ring connectors (quick-connect) .................................................... 3899003433
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
The charger needs to check the
condition of the battery.
The battery is sulfated.
The battery is too large for the
charger.
The battery voltage is still below
10V after 2 hours of charging.
The clamps are not making a good
connection.
The fuse is bad.
• 12 •
REASON/SOLUTION
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for loose fitting plug.
The Green LED will be solid
when the charger is checking
the condition of the battery. This
is normal.
Reset the charger by briefly
unplugging it.
You need a charger with a higher
amp rate.
Have the battery checked.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the
ring connector.