Exmark Metro Series Operator's Manual page 20

Hide thumbs Also See for Metro Series:

Neutral Lock /

Park Brake Latch

Drive Linkage

PISTOL GRIP HANDLES

NEUTRAL LOCK LEVER CLEARANCE

NOTE: Neutral lock/park brake latch clearance should be checked when

there is a slight upward force placed on the drive levers to remove any

"slack" in the linkage.

After clevis pin has been inserted, install hairpin into hole on the clevis pin

between the neutral lock/park brake latch and drive lever (See Figure 10).

Repeat procedure on opposite side of unit.

Clevis Pin

Drive

Lever

Hairpin

DRIVE LEVER HARDWARE LOCATION

For ECS Handles:

a) Locate the drive lever linkages which have the balljoint and jam nuts installed on

one end. Locate the (2) 5/16-18 x 1 3/4 Hex cap screws and (2) 5/16-18 nyloc

nuts in the bolt bag. Thread drive lever linkage into the swivel located on the

wheel drive idler arm. Thread in until the flat edge of the drive lever aligns with

bottom of the roller notch in the neutral lock/park brake latch when the 5/16-18 x 1

3/4 hex cap screw is inserted through the hole in the drive lever and the hole in

the balljoint. Secure with the 5/16-18 nyloc nut. Tighten nut. Repeat for the

other side. See Figures 11 and 12.

3/16" TO 1/4"(.47-.64 cm)

FIGURE 9

FIGURE 10

PISTOL GRIP HANDLES

- 15 -

Drive Linkage

Left Side

Shown

Neutral Lock /

Park Brake Latch

Table of Contents