Exmark Metro Series Operator's Manual page 17

Hide thumbs Also See for Metro Series:

IMPORTANT: If the mower has been completely assembled and the handle

position is changed, it will be necessary to readjust the drive and brake linkage.

UPPER HANDLE HEIGHT ADJUSTMENT

3.9

Attach throttle cable to engine.

For Kohler engines with "positive" detents in throttle cable for both idle and

full throttle positions.

a) Position the throttle control lever (on console) in the full throttle (but not choke)

position. You will feel a detent when the throttle control lever is approximately

3/4" (2 cm) from the upper end of the slot -- this is the full throttle position.

b) Route the throttle cable along the right side of the upper handle, under the fuel

tank support and to the left side of the engine.

c) Loosen clamp on engine control plate. (See Figure 3). Attach inner wire of the

throttle cable to the control plate lever and position cable under clamp, do not

tighten clamp.

FIGURE 1

UPPER HANDLE MOUNTING

FIGURE 2

FIGURE 3

KOHLER SPEED CONTROL

(THROTTLE CABLE HOOK-UP)

- 12 -

Table of Contents