HP ProLiant DL320 Maintenance And Service Manual page 46

Observe the following guidelines when installing additional memory:
•
DIMMs must be industry-standard, 128-MB, 256-MB, 512-MB, or 1-GB,
3-cm (1.2-in), 184-pin PC2100, 266-MHz DDR ECC memory DIMMs. The DDR
memory DIMMs must support CAS Latency 2, where CL=2 or greater. They must also
contain the mandatory Joint Electronic Device Engineering Council (JEDEC) Serial
Presence Detect (SPD) information.
•
DIMMs installed in the server must be registered DDR, 2.5 volts and 64-bits wide.
•
Do not mix ECC and non-ECC DIMMs or DIMMs of different speeds. If different types
of DIMMs are mixed, the system will not properly function.
IMPORTANT: A DIMM can be installed only one way. Be sure to match the key slots on the module
with the tabs on the memory slot. Push the module down into the slot until it is fully inserted and
properly seated. The system will not recognize improperly aligned or seated DIMMs.
To replace a DIMM from the system board:
1. Power down the server. See "Powering Down the Server" in this chapter.
2. Remove the access panel. See "Access Panel" in this chapter.
3. Press both memory module socket latches outward (1). This action releases the module
and partially lifts it out of the socket.
4. Lift out the memory module (2).
Figure 2-29: Removing a DIMM from a DIMM socket
5. Align the key slot in the bottom edge of the DIMM with the tab in the expansion socket.
HP ProLiant DL320 Generation 2 Server Maintenance and Service Guide
HP CONFIDENTIAL Codename: Moonstar 266 Part Number: 293164-002 Last Saved On: 4/14/03 9:37 AM
CAUTION: ESD can damage electronic components. Ensure that you are properly grounded
before beginning any installation procedure. Refer to "Electrostatic Discharge Information" in
this chapter.
Removal and Replacement Procedures
2-35