GE J2B912 Owner's Manual & Installation Instructions page 51

Problem Possible Causes
Display goes blank
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the
black-out mode.
Display flashes Power failure.
Unable to get the Oven control pads were
display to show "SF"
not pressed properly.
Power outage,
Power outage or surge.
clock flashes
"Burning" or "oily"
This is normal in a new oven
odor emitting from and will disappear in time.
the vent
Strong odor
An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
Drawer does not slide The drawer is out of alignment. • Fully extend the drawer and push it all the way in.
smoothly or drags
Drawer is over-loaded or load
is unbalanced.
Warming drawer will A fuse in your home may be
not work
blown or the circuit breaker
tripped.
The oven is self-cleaning.
Controls improperly set.
Excessive condensation
Liquid in drawer.
in the drawer
Uncovered foods.
Temperature setting too high.
Food dries out in the Moisture escaping.
warming drawer
Drawer not fully closed.
What To Do
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
See the Care and cleaning of the range section.
• Reduce weight. Redistribute drawer contents.
• Replace the fuse or reset the circuit breaker.
• Wait for the self-clean cycle to finish and the oven
to cool.
• See the Electric warming drawer section.
• Remove liquid.
• Cover food with lid or aluminum foil.
• Reduce temperature setting.
• Cover food with lid or aluminum foil.
• Push drawer in until latch engages.
ge.com
51