Custom Configuration - Planet ENW-3502-T User Manual

PLANET ENW-3502-T Ethernet PC Card User's Manual
After selecting the Network Operating System, the INSTALL program
will copy and/or modify some files on your boot drive. Your
CONFIG.SYS file will also be modified to include the Client Driver.
You should see the following message if installation has been
successful.
PLANET ENW-3502-T Ethernet PC Card Installation Program
INSTALL has created/modified your AUTOEXEC.BAT and CONFIG.SYS file to
enable the 10Mbps Ethernet Card. The original file has been renamed to
AUTOEXEC.PCM and CONFIG.PCM. If you have any problems with the new
CONFIG.SYS file when you reboot your computer, you should restore the original
files.
Please remove the Driver Installation Disk and reboot your computer.

6.2.1.2 Custom Configuration

To do a custom installation, you need to select the Custom Configuration
Menu after you begin the INSTALL program.
After selecting the Custom Installation Menu, you will see a series of
submenus prompting you to select an IRQ , I/O port and Memory address.
Interrupt Select
The first submenu which will appear is the Interrupt submenu. To select an
interrupt, move the cursor to the interrupt of your choice and select it by
pressing < >. Interrupts available for your 10Mbps Ethernet card include
Enter
2, 3, 4, 5, 6, 10, 11, 12 and 15.
20
INSTALLATION SUCCESSFUL !
Press any key to return to DOS
Figure 6-2.6 Successful Installation Screen