Table of Contents
Advertisement
Chapter 5
Driver Installation for Windows NT 4.0
The installation procedure assumes the network component has been
installed on your computer. To check whether the network component
has been installed, double click the Network icon in Control Panel. If it
has not, refer to the Windows NT 4.0 installation guide to install the
component.
While installing the network component, Windows NT 4.0 will ask you
to install the driver of network adapter. The driver installation
procedure is similar to the following one.
Follow the steps below to install the driver.
1. Insert the PCMCIA 10Mbps Ethernet Card into an open PCMCIA slot on
your notebook. Login to NT 4.0 as the administrator.
2. Doublic click Network icon in Control Panel, and select Adapters tab,
the Figure 5.1 displayed.
3. Click Add to add a new adapter, the window, Figure 5.2, popped up.
10
Figure 5.1 Network Window
Advertisement
Table of Contents
