The Install Program; Using The Install Program - Planet ENW-3502-T User Manual

4. Turn off your computer and insert the ENW-3502-T Ethernet PC
Card into the PCMCIA socket. The card is keyed to go in one way
only. Then attach the network cable to the card.
5. Now turn your computer on and connect to your network. If you cannot
connect to the network, refer to the Appendix A and B.

6.2 The INSTALL Program

Before you can use your ENW-3502-T Ethernet PC Card, you need to
install and modify some files in your computer system. You can make
these changes manually, or you can let the INSTALL.EXE program do
them for you.
This section explains how you can use the INSTALL.EXE program to
install the enabler and the files needed by the network operating system.

6.2.1 Using the INSTALL Program

To run the INSTALL.EXE program, type
DOS prompt. You should see an opening screen which welcomes you to the
program and asks if you wish to continue.
PLANET ENW-3502-T Ethernet PC Card Installation Program
Welcome to 10Mbps Ethernet Card Installation Program. INSTALL will set up
your 10Mbps Ethernet Card.
If you have your network operating system installed, please insert your Card in
any available PCMCIA slot on your computer and press <Enter> to continue.
Otherwise press <F3> to return to DOS.
Press <
DO YOU WANT TO PROCEED?
<Enter> to continue <F3> to return to DOS
Figure 6-2.1 Opening Screen
> to continue the installation.
Enter
Chapter 6 Client Driver Installation
and press <
INSTALL
> at the
Enter
15