Table of Contents
Advertisement
Your Curtis G4/Gold Cup Series is Factory Pre-Set for Optimum Performance.
After connection to water and power; turn on the brewer at the rear toggle switch. You will hear a beep and the status lights will come on for
a moment.
The screen will display
When the proper level is reached
ture.
Control will display
READY TO BREW
COFFEE BREWING INSTRUCTIONS
1. Brewer should be ON. Confirm this at the toggle switch on the back of the water tower, the lower right side. The touch-screen should read
Ready to Brew.
2. Place an empty coffee container centered beneath the brew head.
WARNING – TO AVOID SCALDING, Do not remove brew basket while brew light is flashing.
3. Place a clean filter into the brew basket.
6. Start the brew cycle by holding your
finger on the desired brew icon. As soon
as you hear the click of the brew valve,
the brew cycle has started and you can
lift your finger.
Brew Code: You may find that when a brew
button is pressed, a key pad appears on the
. Next
will appear on the screen. It takes approximately 45 minutes to reach the set point tempera-
when temperature reaches the set point. The unit is now ready to brew.
4. Fill the filter with the proper amount of
ground coffee.
screen. This is a brew lock-out feature that
requires a code to be entered before a brew
will start. The default is OFF.
CAUTION: When enabled, as soon as you
enter the brew code a brew cycle starts.
Refer to page 8 for more information about
setting the Brew Code.
is displayed. Water will fill the tank (3-5 minutes depending on water flow rate).
5. Slide the filled brew basket into the brew
rails on the brew head.
During the brew cycle, an animated coffee
cup icon will appear on the screen and a
brew timer will count down the time remain-
ing on the brew cycle.
7
Advertisement
Table of Contents
