Operation; Turning On The Power; Setting The Squelch Level - Uniden UH8010S+ANT Owner's Manual

Operation

Turning on the Power

Press and hold the Power/Channel Selector.
Low-Voltage/High-Voltage Alert
If the power supply voltage exceeds 18VDC, an alert tone
sounds and dc HI flashes for 5 seconds. The power source
must not exceed 25VDC otherwise permanent damage
may occur to your radio, which may not be covered by the
manufacturer's warranty.
If the input voltage falls below 10VDC, dc Lo flashes for 5
NOTE
seconds. The power turns off automatically if voltage falls
below 8.5VDC.
Switch your UH8010S/UH8020S OFF and disconnect it from
the power source, before locating the cause of the power
supply problem.

Setting the Squelch Level

Press the Power/Channel Selector momentarily. SqL shows and the
current squelch level will flash.
Turn the Channel Selector to select the desired squelch level.
UNIDEN UH8010S/UH8020S
12
UHF CB Transceiver