Download Print this page

U Sing The I Ron ' S S Pecial F Eatures; S Toring Y Our I Ron - Sunbeam GCSBBV212 Instruction Manual

Classic iron

Advertisement

t
f
W
R
o
Ill the
ateR
eseRvoIR (use tap water)
1. Make sure the iron is unplugged. Set the Steam Dial to
Select Dial to MIN.
2. Lift the Water Fill Hole Cover.
3. Fill an easy-pour measuring cup with tap water and pour water into iron water
reservoir. Do not fill water reservoir beyond maximum fill level.
WARNING:
To prevent the risk of burns, be careful when filling a hot iron with
water. Hot metal parts, hot water and steam can cause injuries.
d
I
Ry
RonIng
1. Make sure the Steam Dial is turned to the
2. Plug the cord into a 120-Volt AC outlet.
3. Turn the large Fabric Select Dial to the fabric setting you desire. Allow the iron
to heat for 2 minutes. While the iron is heating, make sure it is sitting on its
heel rest on a stable, protected surface.
NOTE:
While the Steam Dial is turned to the
the Shot of Steam
or Spray Mist feature, as long as the Fabric Select Dial is set
®
to wool, cotton, or linen. Please make sure the water reservoir is approximately ¼
full of water.
s
I
team
RonIng
1. Follow the instructions for "Filling the Water Reservoir."
2. Plug the cord into a 120-Volt AC outlet.
3. Turn the Fabric Select Dial to the fabric setting you desire. Allow the iron to
heat for 2 minutes. While the iron is heating, make sure it is sitting on its heel
rest on a stable, protected surface.
IMPORTANT:
When not ironing, always set the Steam Lever to
Fabric Select Dial to MIN.
u
sIng the
s
m
f
is a powerful water spray mist that dampens the fabric to
pRay
Ist
eatuRe
aid in removing wrinkles from heavy fabrics and for setting creases.
t
s
m
f
o use the
pRay
Ist
eatuRe
s
s
f
®
provides an extra burst of steam for deep
hot of
team
eatuRe
penetration of stubborn wrinkles. You can use this feature while Dry or Steam
ironing, as long as the Fabric Select Dial is set to wool, cotton, or linen. The water
reservoir must be approximately ¼ full of water.
t
s
s
o use the
hot of
team
and press the Shot of Steam
button each time you would like an extra burst of
®
steam. The Shot of Steam
®
feature may be used continuously in approximately
3-second intervals.
v
s
allows your iron to function as a garment steamer.
eRtIcal
team
TIP:
When using vertical steam on clothing, hang the clothing on a clothes hanger
for best results. Hanging curtains and drapes may also be steamed.
t
u
v
s
:
o
se
eRtIcal
team
1. Make sure that the iron has heated up (2 minutes).
2. Hold the iron in a vertical position, with the iron close to but not touching the
12
Visit www.sunbeam.ca for an Ironing Guide and Ironing Tips
Voyez le guide et les conseils de repassage au www.sunbeam.ca
(Dry) and the Fabric
(Dry) setting.
(Dry) setting, you may still use
I
'
s
f
Ron
s
pecIal
eatuRes
:
Press the Spray Mist button firmly.
f
:
®
Place the iron on top of the wrinkle
eatuRe
11
damage the cord.
s
toRIng
1. Turn off iron following instructions abov
2. If you do not use your iron on a daily ba
each use for a longer iron life. To do so,
down, open the fill hole cover, and allow
the iron gently to remove trapped water
3. Loosely loop the power cord around the h
IMPORTANT:
the cord.
c
leanIng the
soleplate if starch or other residue accumul
t
o clean the
damp cloth.
WARNING:
the soleplate. This will damage the finish. R
remove any residue.
u
sIng
once a month to maintain the optimal perfo
t
o use the
Turn off iron following instructions above.
1. Fill the water reservoir with tap water to
2. Plug in the iron, set the Fabric Select Dia
(Dry) and the
for 2 minutes.
3. Unplug the iron.
4. Hold the iron over a sink in a horizontal
WARNING:
5. Press the Self-clean Button and hold. Wa
vents. Slowly rock the iron side to side a
rocking the iron, dip the nose of the iron
make certain the water circulates comple
one minute.
6. Open the fill cap, turn the iron upside do
flow out of the fill hole.
7. Dry the soleplate with a towel.
8. Plug in the iron and set the Fabric Select
2 minutes to dry out the iron completely
9. Set the Fabric Select Dial to MIN, unplu
R
emplIssage du RéseRvoIR (utilisez de l'eau
1. Assurez-vous que le fer soit débranché. R
et le cadran de sélection des textiles à M
2. Levez le volet pour ouvrir l'orifice de rem
y
I
ouR
Ron
Wrapping the cord aroun
m
y
aIntaInIng
s
:
turn off iron
oleplate
s
:
allow the iron
oleplate
DO NOT use abrasive cleans
t
s
-c
f
he
elf
leanIng
eatuRe
s
-c
elf
leanIng featuRe
Be careful not to touch the ir
ou
:
Y
:

Advertisement

loading