Using Self-Clean Future; Maintaining Iron; M Aintaining Y Our I Ron - Sunbeam Turbo Steam Instruction Manual

s s
hot oF team
wrinkles. You can use this feature while Dry or Steam ironing as long as the Fabric Select Dial is set to wool, cotton,
or linen. The water reservoir must be at least ¼ full of water.
TO USE: Place the iron on top of the wrinkle and press the Shot of Steam
burst of steam. The Shot of Steam
v s
ertIcal hot oF
steamer.
TIP: When using vertical steam, hang clothing on a hanger for best results. Hanging curtains and drapes may also
be steamed.
TO USE:
1. Ensure that the iron is heated up and the Ready indicator light has turned solid blue.
2. Hold iron vertically near, but not touching the fabric you want to steam. Pull the fabric tight.
3. Press Shot of Steam
®
WARNING: To prevent burns, keep hands away from the area being steamed.
WARNING: DO NOT steam garments while wearing them; this may result in injuries.
3-W
ay
Turns iron off if left in one position too long to avoid accidents.
IF YOU LEAVE IRON ON:
• I f auto-off activates the unit will beep 6 times and the red light will blink until reset.
• H orizontally without moving it, or accidentally tip the iron over, it will automatically stop heating after 30 seconds.
• V ertically (on its heel rest) without moving it, the iron will automatically turn off after 15 minutes.
IMPORTANT: When the auto-off feature has been activated, the unit will beep 6 times and the indicator light will
blink.
TO RESET: Move iron back and forth and reheat until the "Ready" indicator light turns solid blue.
c
arIng For
TURNING OFF IRON: Turn Steam Lever to
WARNING: NEVER yank power cord when unplugging iron. This can damage the cord.
Empty water reservoir completely after each use.
1. Turn off iron, unplug and allow to cool.
2. Empty water reservoir after each use for a longer iron life.
3. Loosely loop the power cord around the heel rest and store the iron on its heel rest. IMPORTANT: Wrapping the
cord around the iron too tightly can damage the cord.
u s -c
sIng elF lean
1. Turn off and unplug iron.
2. Move Steam Lever back and forth to remove debris and minerals from Steam Valve. This keeps water flowing into
the steam chamber.
3. Fill water reservoir with tap water to MAX line.
4. Plug in iron, press Fabric Select Button to select Linen setting and heat until the indicator light turns solid blue.
s F
pecIal eatures
®
F
eature provides an extra burst of steam for deep penetration of stubborn
feature may be used continuously in approximately 3-second intervals.
®
®
s F
team
button in 3-second intervals as you move iron over wrinkles.
m s
otIon mart
y
(Dry) and Fabric Select Dial to Off. Unplug.
s
torIng
m
aIntaInIng
F : Use the Self-Clean feature once a month to maintain optimal iron performance.
eature
(continued)
®
eature allows iron to function vertically as a garment
a
uto
TM
I a
our ron
y I
our ron
y
our
button each time you would like an extra
-o F
FF eature
u
Fter se
I
ron