Onkyo TX-NR 838 Manual page 101

enabled device.
"On": Use this function
"Off": Do not use this function
Setting to "On" increases the power consumption even when the unit
is on standby. However, the increase in power consumption is kept
to a minimum by automatically entering the HYBRID STANDBY
mode, where only the essential circuit is operating.
This setting is fixed to "Off" if "Direct Change" is set to "Off".
Pairing Information
Default Value: –
When paring is performed, the information of the previous pairing stored
in this unit will be initialized.
Pressing ENTER when "Clear" is displayed initializes the pairing
information stored in this unit.
This function does not initialize the pairing information on the
Bluetooth-enabled device. When pairing the unit again with the
device, be sure to clear the pairing information on the Bluetooth-
enabled device in advance. For information on how to clear the
pairing information, refer to the Bluetooth-enabled device's
instruction manual.
Device
Default Value: –
Displays the name of the Bluetooth-enabled device connected to the
unit.
The name is not displayed when "Status" is "Ready" and "Pairing".
Status
Default Value: –
Displays the status of the Bluetooth-enabled device connected to the
unit.
"Ready": Not paired
"Pairing": Paired
"Connected": Successfully connected
Wait for a while if "Bluetooth" cannot be selected. It will appear when the
network function is started up.
Firmware Update