Garmin GPS 400W Installation Manual page 114

Once the Signal Acquisition Test has been completed successfully, perform the following steps:
1. View the Satellite Status Page and verify that at least 7 satellites have been acquired on the 400W
Series unit.
2. Verify that the GPS "INTEG" flag is out of view.
3. Select 121.150 MHz on the COM transceiver to be tested.
4. Transmit for a period of 35 seconds.
5. Verify that the GPS "INTEG" flag does not come into view.
6. Repeat steps 4 and 5 for the following frequencies:
25 kHz COM Channel Spacing
121.150 MHz
121.175 MHz
121.200 MHz
121.225 MHz
121.250 MHz
131.200 MHz
For VHF radios with 8.33 kHz channel spacing, include the following frequencies in
addition to those listed above.
8.33 kHz COM Channel Spacing
121.185 MHz
121.190 MHz
7. Repeat steps 3 through 6 for all remaining COM transceivers installed in the aircraft.
8. If aircraft is TCAS-equipped, turn on the TCAS system and verify that GPS position remains
valid (if position is lost, the status on the Satellite Status Page will change to "ACQUIRING").
9. If aircraft is SATCOM-equipped, use the SATCOM system and verify that GPS position remains
valid (if position is lost, the status on the Satellite Page will change to "ACQUIRING).
10. If the GPS "INTEG" flag comes into view, see Section 2.4.6 for options to improve performance.
Page 5-30
Rev. G
131.225 MHz
131.250 MHz
131.275 MHz
131.300 MHz
131.325 MHz
131.350 MHz
NOTE
130.285 MHz
131.290 MHz
400W Series Installation Manual
190-00356-02