3.2
DIP Switch Setting
The DIP switch S2 sets up the system according to the equipment connected. In the default setting
all switches (1-8) are OFF. The DIP switch S3 should not be adjusted; leave all switches in the
OFF position.
NavNet,Navnet vx2, NavNet TZtouch
Switch
No.
1
Power on/off by NavNet equipment OFF: Power sync (for NavNet 3D)*
2
Automatic/Manual IP address
selection
3 - 6
Manual IP address assignment
7
Restore default settings (other than
LAN and transducer)
8
Restore ALL default settings
*: Power sync setting enabled at NavNet 3D.
S2
S3
DIP Switches
(factory settings)
#1: ON
#2: ON
#3 - #6: See next page.
#7: OFF
#8: OFF
DIP SW2 settings for
DIP switch S2 description
Function
DIP SW2 settings for
NavNet 3D
ON: No power sync (for NavNet/NavNet vx2/
NavNet TZtouch)
OFF: Automatic IP address assignment. Use this
setting for NavNet/NavNet vx2/NavNet TZtouch.
ON: Manual IP address assignment. Use this setting
for NavNet/NavNet vx2/NavNet TZtouch and refer to
the table on the next page for IP addresses.
Valid when switch no. 2 is ON. For connection of mul-
tiple network sounders, assign each one an IP ad-
dress with the Mode DIP switch, referring to the table
on the next page.
See section 4.3.
See section 4.3.
16
3. INITIAL SETTINGS
ALL OFF
Setting