Dip Switch Setting - Furuno Network Sounder DFF3 Operator's Manual

3. INITIAL SETTINGS
3.2

DIP Switch Setting

The DIP switch S2 sets up the system according to the equipment connected. In the default setting
all switches (1-8) are OFF. The DIP switch S3 should not be adjusted; leave all switches in the
OFF position.
S2
S3
Switch
No.
1 Power on/off by NavNet or NavNet
3D
2 Automatic/Manual IP address
selection
3 - 6 Manual IP address assignment
7 Restore default settings (other than
LAN and transducer)
8 Restore ALL default settings
*1: Power sync setting enabled at NavNet 3D.
DIP Switches
DIP switch S2 description
Function
OFF: Power sync (for NavNet 3D)
ON: No power sync (for NavNet)
OFF: Automatic IP address assignment. Use this
setting for NavNet 3D.
ON: Manual IP address assignment. Use this setting
for NavNet, and refer to the table on the next page for
IP addresses.
Valid when switch no. 2 is ON. For connection of mul-
tiple network sounders, assign each one an IP ad-
dress with the Mode DIP switch, referring to the table
on the next page.
See section 4.3.
See section 4.3.
16
Setting
*1