3.3
Operation Check
For NavNet, NavNet vx2 and NavNet TZtouch, the DFF3 is powered on/off from ship's switch-
board. For NavNet 3D, it is powered on/off from the display unit. The LED on the cover of the DFF3
lights or blinks according to equipment state, as described in the table below.
LED state
Lighting continuously
Blinking every two seconds
Blinking every 0.4 seconds
LED state and meaning
• Standby state. (If, for NavNet series, no signal is received via
LAN for more than 10 minutes, the equipment automatically goes
into standby to lessen power consumption.)
• Power on (20 seconds during initialization)
• IP address not set
Normal operation
Transducer settings at NavNet series not properly set.
LED
18
3. INITIAL SETTINGS
Meaning