Free Rate Function - JVC DR-MV1S Instructions Manual

OPERATIONS ON DVD DECK
42
EN

Free Rate Function

To record the entire programme, the unit automatically set the
appropriate recording mode depending on the combination of the
total time of the programme to be recorded and either the
remaining disc space or the specified recording time (from 60
minutes to 480 minutes).
8 To record the entire programme within the actual remaining
disc space
Select "FR (JUST)" in a recording mode selection procedure.
( pg. 43, 45)
● Note that this function is available only for timer programming
recording.
8 To record the entire programme by specifying the desired
recording time
Select "FR60–FR360", "FR420" or "FR480" in a recording mode
selection procedure. ( pg. 40, 43, 45)
8 To record a 25-min. long daily programme five times just on
a same disc for example
Perform "S V TM Timer Programming" (
HOW IEW
Be sure to set the recording mode to "FR125" and set Weekly/Daily
Rec Function to "MON–FRI" in step 6 to fit the total recording time
to the whole disc space.
Blank
When the same programme is recorded in SP mode instead of in
"FR125", the 5th programme cannot be recorded.
Blank
NOTES:
● You can programme this unit to timer-record, regardless of the disc
● The maximum recording time of FR (JUST) mode is the same as the
● Even if more than one programme are timer-programmed in FR
● In order to ensure that the recording fits on the disc, this feature may
● There may be some noise and sound disturbance at the point on the
pg. 43) procedure.
Receiving Stereo And Bilingual Programmes
Your unit is equipped with a Sound-Multiplex decoder (A2) and a
Digital stereo sound decoder (NICAM) making reception of stereo
A: 1st and bilingual broadcasts possible.
B: 2nd
When the channel is changed, the type of broadcast being
C: 3rd
received will be displayed on the TV screen for a few seconds.
D: 4th
E: 5th
Type of Broadcast Being
Received
A2 Stereo
A2 Bilingual
Regular Monaural
NICAM Stereo
A: 1st NICAM Bilingual
B: 2nd
NICAM Monaural
C: 3rd
NOTES:
D: 4th
● "SUPERIMPOSE" must be set to "AUTO". Otherwise the on-screen
E: Blank (20 min.)
● If the quality of stereo sound being received is poor, the broadcast
Selection Of The Audio Channel To Be Recorded On A
Disc
When a programme is recorded on a DVD-RAM or DVD-RW disc in
VR mode, all audio channels of the receiving programme are
recorded on the disc. When you record a programme on a DVD-R
or DVD-RW disc in video mode, select the desired audio channel
(from among "NICAM 1/MAIN", "NICAM 2/SUB", "MONO") to be
recorded on the disc. (
NOTE:
Before playing back a programme recorded in stereo, or a bilingual
programme, refer to "Audio Channel Selection" on page 28.
remaining time. When the disc remaining time is not enough,
recording may stop in the middle of a programme. To avoid this, make
sure of the disc remaining time before setting timer-programming.
(Example) If you programmed to timer-record for 60 minutes in SP
mode on a 120-minute disc, the disc remaining time would be 30
minutes in XP mode, 60 minutes in SP mode, 120 minutes in LP
mode, 180 minutes in EP mode, and 240 minutes in FR480 mode.
Timer-recording will not complete beyond these remaining times.
recording time of FR480 mode. When timer-programming a long
programme in FR (JUST) mode on a disc whose remaining time is
short, it is recommended checking the disc remaining time in FR480
mode to see if the remaining time is enough for the programme.
(JUST) mode, only the first one is recorded.
leave a slight non-recorded section at the end of the disc.
disc where the unit switches the mode.
displays will not appear. ( pg. 79)
might be received in monaural with better quality.
pg. 79)
On-screen Display