Connecting To An Ibm 468X/469X Host - Motorola symbol ds9808 Reference Manual

8 - 2 Symbol DS9808 Product Reference Guide

Connecting to an IBM 468X/469X Host

Connect the digital scanner directly to the host interface.
Host Port Connector
IBM Direct Connection
Figure 8-1
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the digital scanner
are the same.
Attach the modular connector of the IBM 46XX interface cable to the cable interface port on the digital scanner.
1.
See Installing the Interface Cable on page
Connect the other end of the IBM 46XX interface cable to the appropriate port on the host (typically Port 9).
2.
Select the port address by scanning the appropriate bar code from
3.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
4.
NOTE The only required configuration is the port address. The IBM system typically controls other digital scanner
parameters.
Interface Cable
1-3.
Port Address on page
Figure 8-1 are examples
8-4.