Graco 295530 Operation, Parts, Service And Repair page 33

Standard Mixing Chambers
Six standard mixing chambers are available. The following table provides a general description
about use and operational performance of each chamber. Actual pattern sizes and outputs
achieved may vary depending on material viscosity, hose length, condition of equipment, environ-
ment, working pressure, and additional factors.
Designed for operation in confined areas and for spraying 3/8 to 1/2-in. (.7 to
46 Size
1.3 cm) thicknesses. Gun may be held within 4 in. (10.2 cm) of target without
blowing away freshly applied foam. Pattern diameter is approximately 4 in.,
296594 (N-800)
with gun 4-in. (10.2-cm) distance from target. Output is approximately 2 to
296584 (L-800)
3-1/4 pounds/min. (.9 to 1.5 kg/min.).
296590 (L-800-LM)
For the same uses as above. These chambers have an increased output of
46 Size
approximately 3 to 4-1/2 pounds/min. (1.4 to 2.0 kg/min.).
296595 (N-810)
296585 (L-810)
296591 (L-810-LM)
Designed for stud areas of trucks and small- to medium-sized wall applica-
55 Size
tions. Pattern diameter is about 8 in. (20.3 cm), with gun 18 to 20 in. (45.7 to
296597 (N)
50.8 cm) from target. Output is approximately 6 to 8 pounds/min. (2.7 to 3.6
296586 (L)
kg/min.).
296592 (L-LM)
For very large area applications. Pattern diameter is about 9 in. (22.9 cm)
62 Size
with gun 18 to 20 in. (45.7 to 50.8 cm) from target. Output range is about 7
296598 (N)
to 10 pounds/min. (3.2 to 4.5 kg/min.).
296587 (L)
For very large area applications. Pattern diameter is about 10 in. (25.4 cm)
70 Size
with gun 18 to 20 in. (45.7 to 50.8 cm) from target. Output range is about 9
296599 (N)
to 12 pounds/min. (4.1 to 5.4 kg/min.).
296588 (L)
For very large area applications. Pattern diameter is about 14 in. (35.6 cm)
78 Size
with gun 24 in. (60.9 cm) from target. Output range is about 13-1/2 to 16-1/2
296600 (N)
pounds/min. (6.1 to 7.5 kg/min.).
297592 (L)
311320J
Parts
33