Page 1
Part No. 296984 Important Safety Instructions Read all warnings and instructions in the GAP spray gun manual 311322. Save these instructions. Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 Copyright 2006, Graco Inc. is registered to I.S. EN ISO 9001...
Installation Installation 4. Remove side block mounting screws. Care- fully separate each side block from the gun block. If side blocks stick, remove dried chemical. Wipe mating surfaces clean with rag soaked in gun cleaner. If side blocks require servicing, see the 1.
Page 3
Installation 7. Install fittings on hose bracket as shown in assembly onto it. Use another 3/16 in. open . 2. Do not rigidly mount fittings to hose end wrench on flat end of rod assembly to bracket. secure it to piston rod. See F .
Page 4
Installation 13. Remove swivel fittings from side blocks. If 16. Install Iso hose assembly and Resin hose using optional ball valves, remove manual assembly between A and R fittings on side valve assemblies. blocks and hose bracket assembly as shown in F .
Page 5
Parts Parts Note: Parts with reference numbers are included in GAP Wand kit 296984. All other parts are included in standard GAP spray gun assembly. . 7: GAP Wand Assembly 296984 Ref. Ref. No. Part No. Description Qty. No. Part No. Description Qty.
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.