Table of Contents
Advertisement
Introduction to the RP-Series Fireplace:
The complete system will require a RP424PFC firebox,
appropriate venting, suitable termination, and control panel.
Review the installation sequence on page 8 for general
information on preparing for a successful installation of
your fireplace. The RP-Series fireplace is not intended
to be used as a primary heat source and should not be
connected and operated with a thermostat switch.
PVVEX58-300
Vertical Power Vent
PVHEX58-300
Horizontal Power Vent
PVHFL58-300
Horizontal Power Vent
Flush / Louvered
Outer glass
barrier
RP424PFC
Fireplace
RP424PFC major components
Figure 2.
XG0781 - 151104
Introduction
Installation
The RP424PFC includes a protective tempered glass barrier
designed to meet the 2015 safety standard to protect young
children and other at-risk individuals from serious burns.
Appropriate Montigo Venting
Components 5" x 8"
Light Wiring
(not supplied)
RP424PFC Indoor Gas Fireplace
Power Vent Control Cable
(Not supplied. Order required
length from your Montigo Dealer)
Light - Standard
Single Pole On/Off
Switch
(not supplied)
Control Panel
On/Off Switch - Standard
Single Pole On/Off
Switch
(not supplied)
20' low voltage wire supplied
115 VAC 60 Hz
supply from
distribution panel
Control Box Cable
30' supplied standard
Page 7
Advertisement
Table of Contents
