Asus MOTHERBOARD L1N64-SLI WS User Manual page 83

CAS Latency (CL) [Auto]
Configuration options: [Auto] [3.0] [4.0] [5.0] [6.0]
TRCD [Auto]
Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRP [Auto]
Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
Configuration options: [Auto] [5 CLK] [6 CLK] [7 CLK] [8 CLK]... [18 CLK]
1T/2T Memory Timing [2T]
Configuration options: [Auto] [1T] [2T]
MCT Timing Mode [Auto]
Allows you to manually configure the MCT Timing Mode parameters.
Configuration options: [Auto] [Manual]
The following items appear when the MCT Timing Mode item is set to [Manual].
TRRD [Auto]
Configuration options: [Auto] [2T] [3T] [4T] [5T]
TRC [Auto]
Configuration options: [Auto] [11T] [12T] [13T]...[25T] [26T]
Bank Interleaving [Auto]
Sets whether to allow memory accesses to be spread out over BANKS on the same
node or across nodes, decreasing access contention.
Configuration options: [Disabled] [Auto]
Node Interleaving [Auto]
Sets whether to allow memory accesses to be spread out over NODES on the same
node or across nodes, decreasing access contention.
Configuration options: [Disabled] [Auto]
DQS Signal Training Control [Disabled]
Enables or disable the DQS Signal Timing Training control.
Configuration options: [Enabled] [Disabled]
MemClk Tristate C3/ATLVID [Disabled]
Enables or disable the MemClk Tri-Stating during C3 and Alt VID.
Configuration options: [Enabled] [Disabled]
CS Sparing Enable [Disabled]
Configuration options: [Enabled] [Disabled]
Memory Hole Remapping [Enabled]
Enables or disable the memory remapping around the memory hole.
Configuration options: [Enabled] [Disabled]
Power Down Control [Disabled]
Allows DIMMs to enter the power down mode by deasserting the clock enable signal
when DIMMs are not in use.
Configuration options: [Auto ] [Disabled]
ASUS LN-SLI WS -2