Table of Contents
Advertisement
7.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
L1N64-SLI WS Chassis intrusion connector
8.
Power connectors (24-pin EATXPWR, 8-pin EATX12V, 4-pin EZ_PLUG1)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
L1N64-SLI WS ATX power connectors
•
•
2-2
L1N64-SLI
WS
for CPU1
ATX12V
L1N64-SLI
WS
Make sure to connect the 8-pin ATX +12V power plug when installing two
CPUs.
You can either use the 4-pin +12V power plug or 8-pin ATX +12V power
plug when installing only one CPU.
CHASSIS
(Default)
for CPU0
EZ_PLUG1
Chapter 2: Hardware information
EATXPWR
Advertisement
Table of Contents
