Operation Instructions; Controls - Exmark Metro HP Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.12 Route the long unattached wiring harness lead, up the left
3.13 If machine is shipped without muffler installed, install
3.14 For Briggs and Stratton Engines install debris guard to top
3.15 Service Engine: Refer to Engine Owner's Manual.
3.16 GREASE UNIT:
3.17 Follow pre-start instructions as outlined in 4.2.
3.18 Perform any needed adjustments as outlined in the

4. OPERATION INSTRUCTIONS

4.1 Controls

4.1.1
After clevis pin has been inserted, install hairpin into
hole on the clevis pin between the neutral lock/park
brake latch and drive lever (See Figure 11).
procedure on opposite side of unit.
Drive
Lever
Hairpin
DRIVE LEVER HARDWARE LOCATION
d) Adjust brakes by adjusting wingnut on upper end of each
brake rod so that when brakes are engaged there is
approximately 1/4" of clearance between ends of drive
levers and handle grips (See Figure 10)
Note: Adjustment should allow the brakes to be engaged, yet
allow the neutral lock/park brake latches to be moved
into the park brake position, if not the brake
linkages must be adjusted again.
e) Squeeze the drive levers and move both neutral lock/park
brake latches into the neutral lock position. Mower
should move forward and backward freely, if not, readjust
as stated in Sections 3.11c and 3.11d.
hand side of the handle and connect the two terminals (in
any order) to the operator presence control switch
terminals underneath the control console.
Fasten the lead to the handle with two small wire ties
from the bolt bag, one at the upper end of the handle
next to the console, and one at the very lower end of
the handle where it attaches to the fuel tank support.
muffler with hardware provided.
of engine.
NOTE: UNIT IS NOT GREASED AT THE FACTORY.
Refer to 5.1.13, for locations and grease amounts.
Adjustment Section.
Operator Presence Control (OPC) Levers: Located on the upper
handle assembly directly above the handle grips. When these
levers are depressed, the OPC system senses that the operator
www.mymowerparts.com
Clevis Pin
FIG. 11
- 14 -
Repeat
Drive Linkage
Left Side
Shown
Reference for
Position Only
Neutral
Lock/Park
Brake Latch