Exmark Metro HP Operator's Manual page 17

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.9
3.10 Install and adjust shifter lever.
a) Remove the 3/8" nyloc nut and spring disc washer from the
b) Shift lever to second gear and check alignment of lever in
c) Shift to neutral position. Lever Should not contact the left
the throttle linkage to the full throttle position. Tighten
the cable clamp screw.
Connect the blade engagement linkages. Loosen jamnut and remove
turnbuckle from lower linkage. Screw turnbuckle onto both upper
and lower linkages simultaneously. (See figure 5) Note that the
threads on upper linkage are left hand. See 5.2.2 for linkage
adjustment.
BLADE ENGAGEMENT LINKAGE
stud on top of the transmission. Install the shifter lever
through slot in shifter lever plate and onto the stud on top
of transmission. Be sure the square-hole washer remains
between the lever and transmission. Replace the spring disc
washer and nyloc nut(see figure 6). Torque the 3/8" nut to
35ft. lbs. (47N.M).
slot of shifter plate.
the top of the slot should be about equal to the clearance
between bottom of the lever and the bottom of the slot
(See figure 7). If it is not, remove lever and bend it
slightly to adjust.
to transmission.
edged of the upper slot.
contact the right edge of the bottom slot (See Figure 8).
Shifter plate can be adjusted side to side to adjust
position of lever relative to the slot in plate.
two bolts securing the shifter plate to the shifter lever
legs. Adjust shifter plate and retighten bolts.
FIG. 6 SHIFTER LEVER TO TRANSMISSION
www.mymowerparts.com
FIG 5
Clearance between top of lever and
DO NOT Bend lever while it is attached
Reinstall lever and tighten hardware.
Push lever down.
THIS CLEARANCE SHOULD BE EQUAL
- 12 -
Lever should not
Loosen the
FIG. 7