Chapter 5
9) Adjust the 3 push switches (SW383, 384) so that
there is no gap [D] between the saddle guide plate
[1] and the edge of the paper [2].
The method of adjustment is as follows:
A press on SW383 [3] causes the guide plate to
move to the left, while a press on SW384 [4]
causes it to move to the right.
Range of adjustment: +10 to -10 (unit of
correction: 0.2 mm)
SW382
SW381
SW383
SW384 SW385
(-)
(+)
ENTER
[3]
[4]
[1]
[2]
F-5-116
10) Press the push switch SW385 once to end
adjustment mode.
5.3.2.16 Adjustment of EEPROM (IC107)
on the Finisher Controller PCB After
Replacement
Adjustments after replacing the EEPROM (IC107)
on the finisher controller PCB
These adjustments are performed when the
EEPROM (IC107) on the finisher controller PCB
has been replaced.
1) Turn on the finisher.
2) Turn on the copier and set the copier in a stand-by
mode.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
5-38
[D]
[D]
A
B
4) Detach the switch cover [1] by removing the
screw [2].
0015-2244
F-5-117
[1]
[2]
F-5-118
[1]