Chapter 5
[3]
[4]
[2]
[1]
F-5-27
5.3.2.2 Adjusting the Angle of the Aligning
Plate (orthogonal)
Go through the following steps if you have replaced
the alignment motor of the intermediate handling
tray assembly or the EEPROM of the finisher
controller PCB:
1) After mounting the intermediate handling tray
assembly, loosen the 2 screws [2] on the aligning
plate [1] of the assembly.
[2]
F-5-28
5-12
[A]
[1]
[2]
2) Fix the 2 paper edge stoppers [1] in place on the
host machine using 2 screws [2].
0015-2226
[2]
[1]
F-5-29