Chapter 2
6) Lift up the rear latch plate [1] to fit the pin and fix
it.
- 1 screw [2] (Use the screw removed in step 4 of
"Before Installing Finisher")
[1]
F-2-18
7) Attach the rear small cover.
8) Remove 1 screw [1] on the rear lower cover of the
finisher.
F-2-19
2-8
[2]
[1]
9) Connect the shunt cable [1].
- 1 screw (Use the ones removed in step 8.)
- 1 screw (Use the included screw for the high-
capacity stacker.)
[3]
F-2-20
10) See "After Installation" to connect the ARCNET
cable to the high-capacity stacker and the
finisher.
2.2.5 After Installation
1) Free the terminal connector [1] from the sub
station.
F-2-21
[1]
[2]
[1]
0016-0907