Ide Configuration - Asus DELUXE P5LD2 User Manual

PIO Mode [Auto] PIO Mode [Auto] PIO Mode [Auto] PIO Mode [Auto] PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
SMART Monitoring [Auto] SMART Monitoring [Auto] SMART Monitoring [Auto] SMART Monitoring [Auto] SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Disabled] 32Bit Data Transfer [Disabled] 32Bit Data Transfer [Disabled]
32Bit Data Transfer [Disabled] 32Bit Data Transfer [Disabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.6 4.3.6 4.3.6

IDE Configuration

IDE Configuration IDE Configuration
4.3.6 4.3.6 IDE Configuration IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you wish to configure the item.
IDE Configuration
Configure SATA As
Onboard IDE Operate Mode
Enhanced Mode Support On
IDE Detect Time Out (Sec)
Configure SATA As [Standard IDE] Configure SATA As [Standard IDE] Configure SATA As [Standard IDE]
Configure SATA As [Standard IDE] Configure SATA As [Standard IDE]
Sets the configuration for the Serial ATA connectors supported by the
Southbridge chip.
The AHCI allows the onboard storage driver to enable advanced Serial ATA
features that increases storage performance on random workloads by
allowing the drive to internally optimize the order of commands.
If you want to create a RAID 0, RAID 1, or the Intel
Technology configuration from the Serial ATA hard disk drives, set this
item to [RAID].
If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, set this item to [Standard IDE].
If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI]. For details on AHCI, go
to: www.intel.com/support/chipsets/imst/sb/CS-012304.htm
www.intel.com/support/chipsets/imst/sb/CS-012305.htm
The SATA controller is set to Native mode when this item is set to [RAID]
or [AHCI].
4 - 1 6 4 - 1 6 4 - 1 6 4 - 1 6 4 - 1 6
[Standard IDE]
[Enhanced Mode]
[S-ATA]
[35]
When in AHCI/RAID
mode SATA
controller is
forced to Native
mode.
® Matrix Storage
C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p