Connecting The Hardware - Minolta dimage scan elite f-2900 Instruction Manual

CONNECTING THE HARDWARE

Connecting the SCSI Cable
This scanner has been packaged with the SCSI cable SC-11 (DB25-to-SCSI-1). See your dealer if
you require a different SCSI cable.
• To meet FCC regulations, the SCSI cables used with this scanner must be equipped with ferrite cores.
1. Place the scanner on a level surface.
2. Connect one end of the SCSI cable to either SCSI
port on the back of the scanner
• Either SCSI port can be used for other configurations, there is no
dedicated in or out port.
3. Connect the other end of the SCSI cable to the
SCSI port on the computer or the last device in
the SCSI chain.
BEFORE YOU BEGIN...
TURN THE COMPUTER AND ALL CONNECTED
DEVICES OFF.
Continued on the following page.
9