Installing The Software Pc/At - Minolta dimage scan elite f-2900 Instruction Manual

INSTALLING THE SOFTWARE – PC/AT
WINDOWS 95/ WINDOWS 98 WINDOWS NT
Dimâge Scan Elite for Windows Setup installs the Twain and Twain_32 driver software into the drive
and folder you select.
• The appearance and/or wording of some dialog boxes may vary depending on the version of Windows running
on your machine.
• These installation instructions assume drive D is the CD-ROM drive.
1. Turn on the scanner, then turn on the PC.
2. Start the Windows operating system.
This step varies with your specific operating software...
Windows 95
• The New Hardware Found dialog box will
appear.
3. Click on Cancel.
• This dialog box may appear several times.
Repeat step 3 until the dialog box no longer
appears.
Windows NT
3. Select Start > Settings > Control Panel, then double-click on the SCSI
Adapters icon. Confirm that Minolta #2885 appears as a connected
device for your SCSI board.
• If Minolta #2885 does not appear, turn the system off and check all the connections. Repeat the
procedure.
4. Insert the Dimâge Scan Elite CD-ROM into the CD-
ROM drive.
Windows 95 Release 2 (OSR2)
and Windows 98
• The Device Wizard dialog box will appear.
3. Click on Next until the Unknown
Device window appears...
...then click on Finish.
• This dialog box may appear several times.
Repeat step 3 until the dialog box no longer
appears.
12