Onkyo TX-8130 Instruction Manual page 36

Cannot access the network server.
0 This unit needs to be connected to the same router as
the network server.
0 Make sure your network server has been started up.
0 Make sure your network server is properly connected
to the home network.
0 Make sure your network server is correctly set.
0 Make sure that the router LAN side port is properly
connected to the receiver.
Playback stops while listening to music files on
the network server.
0 Make sure the network server is compatible with this
unit.
0 When the PC is serving as the network server, try
quitting any application software other than the server
software (Windows Media
0 If the PC is downloading or copying large files, the
playback may be interrupted.
WARNING: If smoke, smell or abnormal noise is
produced by the unit, unplug the power cord from the wall
outlet immediately and contact the dealer or Onkyo
Support.
The unit contains a microcomputer for signal processing
and control functions. In very rare situations, severe
interference, noise from an external source, or static
electricity may cause it to lockup. In the unlikely event
that this should happen, unplug the power cord, wait at
least 5 seconds, and then plug it again.
Onkyo is not responsible for damages (such as CD rental
fees) due to unsuccessful recordings caused by the unit's
malfunction. Before you record important data, make sure
that the material will be recorded correctly.
36
®
Player 12 etc.).
Troubleshooting