Rear - Onkyo TX-8130 Instruction Manual

Rear

REMOTE CONTROL jack: An Onkyo product with
RI jack can be connected and synchronized with this
unit.
FM 75h and AM ANTENNA terminals: The supplied
antennas are connected.
ETHERNET port: Connect to the router with an
Ethernet cable.
Power cord: Connect the power cord to an AC outlet.
Disconnect the power cord only after putting the unit
into standby mode.
*
Turning on the unit may cause a momentary power surge that
might interfere with other electrical equipment on the same
circuit. If this is a problem, plug the unit into a different branch
circuit.
10
Names and functions of parts
DIGITAL IN OPTICAL/COAXIAL terminals:
Connected to players. Use a digital optical cable or
digital coaxial cable for connection with the digital
audio output jack of a player.
GND terminal: Connect if the record player has a
ground wire.
LINE IN terminals: Connected to players. Use an
RCA cable for connection with the LINE OUT terminal
of a player.
LINE OUT terminals: Use when connecting recording
devices, such as a cassette tape deck. Use an RCA
cable to connect to the LINE IN terminal on a recording
device.
SUBWOOFER PRE OUT jack: Connect a subwoofer
with a built-in amplifier to amplify bass output.
SPEAKERS A/B terminals: You can connect a set of
left and right speakers to each of the A/B terminals.